Hello,
I am able to configure an alternate command channel in the PMU test connection and successful receive data.
After selecting “Send Header Frame” and then “Send Config Frame 2” the data starts streaming
How do I set this up on the streamsplitter software, below is what I have tried.
Hello SummerTime1421,
It looks like you’ve set up the 10.1.8.103 IP address as both the network interface over which you are receiving the data from 10.1.8.140 and also the TCP proxy point that you are forwarding the data to. This doesn’t make much sense to me since the computer behind the 10.1.8.103 interface would already be receiving the data stream and should therefore not need to be set up as a proxy point. I’m thinking the source of your issue might be related. Perhaps 10.1.8.103 is not listening on TCP port 7771?
Can you maybe explain a bit more about what you’re trying to do with StreamSplitter?
Thanks,
Stephen
