# Unable to view output on PMU Connection Tester application and RT-Lab

**URL:** <http://discussions.gridprotectionalliance.org/t/unable-to-view-output-on-pmu-connection-tester-application-and-rt-lab/1077>\
**Category:** PMU Connection Tester\
**Created:** [July 11, 2022, 5:54pm UTC](http://discussions.gridprotectionalliance.org/t/unable-to-view-output-on-pmu-connection-tester-application-and-rt-lab/1077 "2022-07-11T17:54:41Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Kinjal](http://discussions.gridprotectionalliance.org/letter_avatar_proxy/v4/letter/k/85e7bf/32.png) [@Kinjal](http://discussions.gridprotectionalliance.org/u/Kinjal)\
**Post date:** [July 11, 2022, 5:54pm UTC](http://discussions.gridprotectionalliance.org/t/unable-to-view-output-on-pmu-connection-tester-application-and-rt-lab/1077/1 "2022-07-11T17:54:41Z")

</div>

I executed a model consisting of IEEE C37 Protocol and IEEE-39 bus system using RT-Lab and Simulink. The model is successfully executed in the software and I can view the output on Simulink. All the plots can be viewed using Simulink scope. However, when I connect this to PMU Connection Tester software, I can not view the output here. I checked other models too and in that case, PMU Tester gives proper plots. From my end, I have configured all the settings properly and verified them many times. Any help is appreciated.

---

<div class="post-metadata">

**Author:** ![ritchiecarroll](http://discussions.gridprotectionalliance.org/user_avatar/discussions.gridprotectionalliance.org/ritchiecarroll/32/2_2.png) [@ritchiecarroll](http://discussions.gridprotectionalliance.org/u/ritchiecarroll)\
**Post date:** [July 12, 2022, 10:50pm UTC](http://discussions.gridprotectionalliance.org/t/unable-to-view-output-on-pmu-connection-tester-application-and-rt-lab/1077/2 "2022-07-12T22:50:16Z")

</div>

Make sure the selected protocol in the PMU Connection Tester is set to IEEE C37.118-2005 - the 2011 will default to trying to use the configuration 3 frame which is not supported by RT-Lab.

Also, make sure the right ID code is selected.

Thanks,  
Ritchie

---

<div class="post-metadata">

**Author:** ![Kinjal](http://discussions.gridprotectionalliance.org/letter_avatar_proxy/v4/letter/k/85e7bf/32.png) [@Kinjal](http://discussions.gridprotectionalliance.org/u/Kinjal)\
**Post date:** [July 14, 2022, 7:04pm UTC](http://discussions.gridprotectionalliance.org/t/unable-to-view-output-on-pmu-connection-tester-application-and-rt-lab/1077/3 "2022-07-14T19:04:55Z")

</div>

I tried connecting using the 2005 protocol but still ‘Device Connection Error’ is showing up. Also, the device ID code is verified.  
This is a weird problem as my output plots are coming up properly on Simulink Scope.  
Thanks,  
Kinjal
