Thanks a lot Stephen for still provide me a time for give me a huge explanation.
- For “Are you able to receive the device configuration in openPDC despite not being able to do so in PMU Connection Tester?” what that happen is the opposite, i can configure connection using PMU Connection Tester, but when i try to configure the device using openPDC by select “Request Configuration”, it’s doesn’t work.
So, i configure the device manually by import the configuration data from PMU Connection Tester. Then after i comple device configuration, my PMU input name STATION_A is apear, but it’s always display red lamp.
Here i confuse because when the STATION_A light in openPDC is red (openPDC cant do data stream), in PMU Tester still doing data stream marked by the phasor graph on PMU tester is continiously display syncrophasor graph.
Why connection tester can provide us syncrophasor graph whilel openPDC with configuration and connection that same with PMU Tester can’t do the same?
- Second, like my privious question " Why the PMU Tester can display synchrophasor data stream whrn the device still not connect with any synchrophasor input? (My case only connect to 3 cable, P and N for PSU and ethernet cable)" as we can see from picture below, the data that recieve by PMU Tester is a phasor data (i can’t provide you the picture when data stream is ongoing because currently i don’t connected to the device but i can show you the phasor configuration from PMU tester that i configure manually to openPDC)
Where when device connected, the PMU Tester will provide data stream from all those phasor.
And then again, Why the PMU Tester can display synchrophasor data stream whrn the device still not connect with any synchrophasor input? I really confuse about this thing 
- SEL 735 instruction manual doesn’t provide any information about IEEE C37.118-2005 instead it’s say that SEL-735 supports protocol defined in IEEE C37.118-2011, but i’ll try to use IEEE C37.118-2005.
But, if the problem is the protocol, why i still can do data stream from PMU Tester using IEEE C37.118-2011?
And as addition, in this manual talk a lot about IEEE C37.118.1 and IEEE C37.118.2 that doesn’t provide in PMU Tester. Do we should include this protocol ?